Atmospheric oxidation chemistry of 1–methoxy 2–propyl acetate initiated by OH radicals: kinetics and mechanisms

Kinetics and mechanism of the gas-phase reaction of CH₃C(O)OCH(CH₃)CH₂OCH₃ (MPA) with OH radicals in the presence of O₂ and NO have been investigated theoretically by performing a high and reliable level of theory, viz., CCSD(T)/6-311?+?G(d,p)//BH&HLYP/6-311++G(d,p)?+?0.9335×ZPE. The calculations predict that the H-abstraction from the ?CH₂?O? position of MPA is the most facile channel, which leads to the formation of the corresponding alkoxy radicals CH₃C(O)OCH(CH₃)C(O ?)HOCH₃ under atmospheric conditions. This activated radicals CH₃C(O)OCH(CH₃)C(O ?)HOCH₃ will undergo further rearrangement, fragmentation and oxidative reactions and predominantly leads to the formation of various products (methyl formate HC(O)OCH₃ and acetic anhydride CH₃C(O)OC(O)CH₃). In the presence of water, acetic anhydride can convert into acetic acid CH₃C(O)OH via the hydrolysis reaction. The calculated total rate constants over the temperature range 263–372?K are used to derive a negative activation energy (E_a= ?5.88 kJ/mol) and an pre-exponential factor (A?=?1.78×10^?12 cm³ molecule^?1 s^?1). The obtained Arrhenius parameters presented here are in strong agreement with the experimental values. Moreover, the temperature dependence of the total rate constant over a temperature range of 263?1000?K can be described by k?=?5.60 × 10^?14×(T/298?K)^3.4×exp(1725.7?K/T) cm³ molecule^?1 s^?1.     

Effects of multi-frequency ultrasound on freezing rates and quality attributes of potatoes

The effects of multi-frequency ultrasound assisted freezing on the freezing rate, microstructure, quality properties (drip loss, firmness, total calcium content, l-ascorbic acid content and total phenol content) of potatoes were studied. The results indicated that the freezing effects of multi-frequency ultrasound was better than those of single-frequency ultrasound. Multi-frequency ultrasound could significantly increase the freezing rate and preserve the quality of frozen samples better. With increase in the number of ultrasonic frequencies, the freezing effect was more obvious. In addition, scan electron microscopy (SEM) images showed that the ice crystals formed by the multi-frequency ultrasonic treatment were fine and uniformly distributed, which caused less damage to the frozen potato samples. From the analysis of the quality attributes, the nutritional values of the samples after multi-frequency ultrasonic treatment was higher, but attention should be paid to the negative influence of the hydroxyl radical generated by the multi-frequency ultrasound.     

多层网络级联失效的预防和恢复策略概述

现实生活中,与国计民生密切相关的基础设施网络大多不是独立存在的,而是彼此之间相互联系或依赖的,于是用于研究这些系统的多层网络模型随之产生.多层网络中的节点在失效或者遭受攻击后会因"层内"和"层间"的相互作用而产生级联效应,从而使得失效能够在网络层内和层间反复传播并使得失效规模逐步放大.因此,多层网络比单个网络更加脆弱.多层网络级联失效产生的影响和损失往往是非常巨大的,所以对多层网络级联失效的预防和恢复的研究具有重大意义.就多层网络级联失效的预防而言,主要包含故障检测,保护重要节点,改变网络耦合机制和节点备份等策略.就多层网络发生级联失效后的恢复策略而言,主要包含共同边界节点恢复、空闲连边恢复、加边恢复、重要节点优先恢复、更改拓扑结构、局域攻击修复、自适应边修复等策略.     

氩气感应耦合等离子体速度与温度数值模拟

为了获得用于研究再入飞行器热防护系统的感应耦合等离子体风洞流场数据，基于流场、电磁场和化学场的多场耦合建立了非平衡态感应耦合等离子体数值模型。利用该模型对不同入口质量流率和不同工作压力下的感应耦合等离子体进行了数值模拟，得到了相应工作参数下感应耦合等离子体温度与速度的分布特性。计算结果表明：等离子体中心线上的速度随着入口质量流率的增大而增大，而随着工作压力的增大而减小；同时，等离子体中心线上的温度随着入口质量流率的增大而减小，而随着压力的增大先减小后增大。这些结果可为感应耦合等离子体风洞优化设计及其工业应用提供理论指导。     

考虑制动力影响的大型客车舒适性分析

利用有限元法和动力平衡原理,建立了具有层间接触的沥青路面和13个自由度的大型客车人体三维模型。以不平顺作为激励,随机模拟车流分布,在不同制动情况下,从时域和频域两方面分析人-车-路耦合振动下车辆和人体的动力响应。时域分析采用客观评价标准和主观烦恼率相结合的方法,频域分析考虑人体共振、人的心理和生理因素。结果表明:随着制动力增大,人体的竖向加速度幅值不变,俯仰、侧倾加速度幅值都增大,但是俯仰加速度增幅远大于侧倾加速度的情况,人的舒适性变差,烦恼率增高;在紧急制动时,主频段对人体共振、心理和生理产生的影响很小,但是次主频段与人体某些器官固有频段重合,对人体共振、心理和生理产生的影响是不容忽视的。     

Development of a capillary electrophoretic method for determination of plasma clearance of iohexol in dogs and cats

Renal function can be monitored by estimation of the glomerular filtration rate (GFR), for example, through measurement of the plasma clearance of a marker that is freely filtrated through the kidney without reabsorption. It has been proposed that iohexol is the most accurate marker for GFR determination in cats and dogs. However, there is a need for a validated capillary electrophoretic method that covers the concentration range for a full curve clearance estimate of iohexol. In the final method, the plasma samples were protein precipitated and the supernatant was analyzed in a background electrolyte containing borate buffer (0.06 m , pH 10.0). The method developed was proved to be linear (concentration range 18– 2900 mg/L) and had a good precision (e.g. 2.3–2.9% at 88 mg/L) and accuracy (e.g. 101–105% at 88 mg/L). Finally, the method was compared with a previously published and validated HPLC‐UV method by parallel analysis of clinical plasma samples from dogs and cats administered Omnipaque®. This comparison showed excellent agreement between the two methods and no proportional or systematic error was observed. The proposed method is simple and has a low cost per sample, which makes it applicable for routine analysis. Copyright © 2014 John Wiley & Sons, Ltd.     

Rate sensitivity and deformation mechanism of semi-crystalline polymers during instrumented indentation

Instrumented indentation tests using both constant loading rate (CLR) and continuous stiffness measurement (CSM) operation modes were performed to investigate the deformation mechanism and their sensitivity to the deformation rate in semi-crystalline polymers through the quantitative analysis of load-depth loading and unloading curves. The strain rate was constant during the CSM tests, while the strain rate decreased with the increasing of loading time in CLR tests. The mechanical response mechanism of the semi-crystalline polymers to these tests was very complicated because of the combined effects of strain-hardening in the crystal phase and strain-softening in the amorphous phase. Results show that the loading index m reflects the strain-hardening or strain-softening response during indentation. When m > 2, the mechanical response was due to the strain-hardening, and when m < 2, the response was due to strain-softening. A method based on the measured contact hardness was proposed to obtain the unloading stiffness, and the other mechanical parameters could then be determined according to the unloading stiffness.     

Monte Carlo simulation of electric conductivity for pure and doping fullerene (C60)

In this paper, we have used Monte Carlo (MC) method to simulate and study the temperature and doping effects on the electric conductivity of fullerene (C60). The results show that the band gap has reduced by the doping and the charge carrier transport is facilitated from valence band to conduction band by the temperature where is touched a 300 K. In this case, the conductivity reached a value of $4\times {10}^{-7}\text{S}{\text{cm}}^{-1}$. The electric conductivity of C60 can increase by the triphenylmethane dye crystal violet (CV) alkali metal to reach $4\times {10}^{-3}\text{S}{\text{cm}}^{-1}$ at 303 K. Our results of MC simulation have a good agreement with those extracted from literature [10], [33].     

Exploring mathematical connections of pre-university students through tasks involving rates of change

This paper reports the results of a research exploring the mathematical connections of pre-university students while they solving tasks which involving rates of change. We assume mathematical connections as a cognitive process through which a person finds real relationships between two or more ideas, concepts, definitions, theorems, procedures, representations or meanings or with other disciplines or the real-world. Four tasks were proposed to the 33 pre-university students that participated in this research; the central concept of the first task is the slope, the last three tasks contain concepts like velocity, speed and acceleration. Task-based interviews were conducted to collect data and later analysed with thematic analysis. Results showed most of the students made mathematical connections of the procedural type, the mathematical connections of the common features type are made in smaller quantities and the mathematical connection of the generalization type is scarcely made. Furthermore, students considered slope as a concept disconnected from velocity, speed and acceleration.